Efficiency is high and shaft power shows full limit load characteristics and there is no overload concern.
Limit load fans are prepared for the following three types.
HLAF energy saving limit load fan
| Uses | Size | Format | Pressure | Features |
|
Industrial use Ventilation and exhaust ventilation Drying and cooling |
2-18 |
Single suction cantilever (S1) Single suction cantilever type (S2) Double suction cantilever (D1, D2) Linear motion type (S6) Coupling direct form Heat resistant form (corresponding to 450 ℃) |
290-2500 PA | It is a fan with a limiter type power characteristic which can be used efficiently even in the region of a large capacity range, and it can correspond to the sirocco fan characteristic region. |
SLAF energy saving limited road wheel fan
| Uses | Size | Format | Pressure | Features |
|
Industrial use Exhaust gas Pollution prevention |
3-18 |
Single suction cantilever (S1) Single suction cantilever type (S2) Double suction cantilever (D1, D2) Linear motion type (S6) Coupling direct form Heat resistant form (corresponding to 450 ℃) |
490-2900 PA | High efficiency shaft power shows full limittroid characteristics, without overload worries and low noise. |
LAF Limited Road
| Uses | Size | Format | Pressure | Features |
|
Industrial use Exhaust gas Hot air drying Exhaust smoke |
2-20 |
Single suction cantilever (S1) Single suction cantilever type (S2) Double suction cantilever (D1, D2) Linear motion type (S6) Coupling direct form Heat resistant form (corresponding to 450 ℃) |
245 to 2450 PA |
The axial force is high efficiency and shows perfect limittroid characteristics, and there is no overload concern. Air foil type impeller is used in general limiter fan. |